204 CHAPTER 23 CLICK 301
e host list supports a minimum of 1 and a maximum of 12 entries. Each entry contains
an IP address and a port number. e host list is owed onto three third-level tabs. If you
need to enter more than the three host IP addresses on the rst screen, go to the IP 4-9 and
IP 10-12 third-level tabs. e three third-level tabs below Ethernet > Hostlist allow you to
congure the hostlist (see Figure 23.15 and Table 23.13).
Figure 23.15 – Expert Driver Hostlist Tabs
Setting Description
Hostlist Enable
Enables the use of the host list.
Retry Counter
Lets you set the number of times the module should attempt to retry
connecting to the host list.
Retry Timeout
Allows you to enter the duration (in seconds) the module should try to
make a connection to the host list before abandoning the attempt.
Host IP Address
Lets you enter the host’s IP address.
TCP Port
Allows you to set the target port number.
Table 23.13 – Expert Driver Hostlist Tabs
Under the Diagnostics tab, you can run diagnostics on your device (see Figure 23.16). Click
the General or Ethernet buttons to run diagnostics on the items listed below each button.
To Next Page
Loading...
