234 CHAPTER 28 CLICK 400
onto the device.
Note
Some settings appear on multiple drivers. Changing one of those settings on any
driver and saving them to the Click device will change that setting on all other drivers
it appears on.
e Backups option can be used to read congurations that have previously been saved to
le. See Chapter 5 for more information.
Application Drivers
e four application drivers have essentially identical elds and settings, so the section that
follows will use images of just one of those drivers as an example. Under the Setup tab, you
can change the settings aecting the setup of the device and sensor (see Figure 27.4 and
Table 27.2).
Figure 27.4 – Setup Tab
e following settings are common to all four application drivers.
Setting Description
Description
Shows a description of the device being configured. This is only for
your information and does not aect the operation of the device.
Location
Displays the location of the device being configured. This is only for
your information and does not aect the operation of the device.
To Next Page
Loading...
