CHAPTER 4 INSTALLING CLICK SUPERVISOR 29
To install Click Supervisor on a handheld computer, you need to have ActiveSync (on Win-
dows XP or earlier) or Windows Mobile Device Center (on Windows Vista). If you do not
have these programs, they are available for download on the Microso website.
If you do not have ActiveSync or Windows Mobile Device Center installed on your com-
puter, skip to the next section, titled Installing Click Supervisor on a PC.
If you do have ActiveSync or Windows Mobile Device Center installed on your computer,
the setup program will detect this and the next screen that comes up will prompt you to se-
lect where you want to install Click Supervisor: a PC, a Pocket PC, or both (see Figure 4.2).
Figure 4.2 – Selecting an Installation
If you select Computer, the program will go through the steps outlined in the next section,
Installing Click Supervisor on a PC. If you select Pocket PC, the program will go through
the steps in the section titled Installing Click Supervisor on a handheld computer. If you
select both, the program will go through both installation processes, beginning with install-
ing on the PC.
Note
Although the software can be installed on most handhelds, because of constantly
changing handheld technologies, Wavetronix can only oer technical support on the
handheld in the kit, which is a Socket Mobile 650.
Installing Click Supervisor on a PC
Follow these steps to install Click Supervisor on a PC:
1 On the screen shown in Figure 4.2, click the checkbox labeled Computer and then
select Next > >.
2 Select an installation location. e default location provided is normally “C:\Program
Files\Wavetronix.” Click Browse to choose another location (see Figure 4.3).
To Next Page
Loading...
