CHAPTER 4 INSTALLING CLICK SUPERVISOR 31
Use these steps to install Click Supervisor on a handheld computer:
1 Ensure that you have ActiveSync or Windows Mobile Device Center installed and that
the handheld is connected to the PC and synced.
2 On the screen shown in Figure 4.2, click the checkbox labeled Pocket PC and then
select Next > >.
3 On the next screen, click Continue > > to start the installation process (see Figure
4.5). e setup program runs the Add/Remove Programs application for Windows
handheld devices. If a handheld device is connected to the computer, Add/Remove
Programs will immediately begin installing Click Supervisor on the handheld device.
If a device is not connected to the computer, Click Supervisor will be downloaded the
next time a handheld device is connected to the computer.
Figure 4.5 – Adding Click Supervisor to a Pocket PC
4 Click OK once the download is complete.
Microsoft .NET Framework
e Click Supervisor setup program will automatically detect whether Microso .NET
Compact Framework v1.1 is installed on your PC. If it is not installed, you will be prompted
to install it (see Figure 4.6).
To Next Page
Loading...
