Frigo Top 10 - 43 | Pordoi 2000 - 4000 13
Label Description Range
Program level
1 2
Lod Instrument display : selects which probe is displayed by the instrument:
P1 = Thermostat probe;
P2 = Evaporator probe.
2
10.3.3 Defrost
Label Description Range
Program level
1 2
tdF Defrost type:
EL = electrical heater;
in = hot gas
2
dtE Defrost termination temperature: (Enabled only when EdF=Pb).
Sets the temperature measured by the evaporator probe, which causes the
end of defrost.
-50 – 50 °C (-58 – 122 °F) 1
idF Interval between defrost cycles:
Determines the time interval between the beginning of two defrost cycles.
0 – 120h 1
MdF (Maximum) length for defrost:
When P2P = n, (no evaporator probe: timed defrost) it sets the defrost du-
ration,
when P2P = y, (defrost end based on temperature) it sets the maximum
length for defrost.
0 – 255min 1
dSd Start defrost delay:
This is useful when different defrost start times are necessary to avoid over-
loading the plant.
0 – 99min 2
dFd Temperature displayed during defrost:
rt = real temperature;
it = temperature at defrost start;
SEt = set point;
dEF = “dEF” label
2
dAd MAX display delay after defrost:
Sets the maximum time between the end of defrost and the restarting of
the real room temperature display.
0 – 255min 2
Fdt Drip time: time interval between reaching defrost termination temperature
and the restoring of the control’s normal operation. This time allows the
evaporator to eliminate water drops that might have formed due to de-
frost.
0 – 120min 1
dPo First defrost after start-up:
y = immediately;
n = after the IdF time
2
dAF Defrost delay after continuous cycle: time interval between the end of the
fast freezing cycle and the following defrost related to it.
0 – 23.5h 2
10.3.4 Fans
Label Description Range
Programm level
1 2
FnC Fans operating mode:
C-n= runs with the compressor, OFF during defrost;
o-n = continuous mode, OFF during defrost;
C-Y = runs with the compressor, ON during defrost;
o-Y = continuous mode, ON during defrost;
1
Fnd Fans delay after defrost: Time interval between end of defrost and evapora-
tor fans start.
0 – 255min 2