Frigo Top 10 - 43 | Pordoi 2000 - 4000 3
1 About this document
1.1 Purpose of the document
This workshop manual is used to support instructed personnel
when adjusting the parameters of the control element for trans-
port refrigeration.
1.2 Using this document
X Read this document before changing parameters.
X Read the operating instructions.
1.3 Use of symbols and highlighting
Explanation
Action to be taken.
Requirements for the following necessary action.
Note on a special technical feature.
Separate information is available.
ATTENTION: Possibility on property damage.
WARNING: Possibility on minor or moderate injury.
DANGER: Possibility on a severe or mortal injury.
1.4 Warranty and liability
Webasto shall not assume liability for defects or damage that are
the result that the installation, operating instructions and as well
as the instructions contained therein being disregarded.
This liability exclusion particularly applies for:
■
Improper use
■
Repairs not carried out by a Webasto service workshop
■
Use of non-genuine parts
■
Conversion of the unit without permission from Webasto
■
Mechanical damage to the equipment
■
Failure to comply with inspection and maintenance instructions
ATTENTION
Misuse as a result of failure to comply with the
workshop manual
Result: damage to the refrigeration system
X Follow the operating instructions and instructions
described in this document.
2 Safety
2.1 General safety
The repair and commissioning personnel must have the following
qualifications:
■
Successful completion of Webasto training.
■
Corresponding qualification for working on technical systems.
■
Certified to work on air conditioning systems.
The repair and installation of the unit may only be carried out in
accordance with the workshop manual and the installation in-
structions.
2.2 Intended use
The system is designed for cooling the load compartment of com-
mercial vehicles while driving.
The performance values of your application are
closely related to ambient conditions, vehicle insula-
tion, etc. The actual temperature may therefore de-
viate from the set value.
In the case of vehicles fitted with automatic start-
stop control, the function must be switched off
while operating the refrigeration system. For infor-
mation on the control and function of the automat-
ic start-stop control, please read the operating in-
structions for your vehicle.
2.3 Versions
■
Fresh produce delivery system:
Cooling temperature can be selected between 0 – 40°C
(32 – 104°F).
■
Fresh produce delivery system with constant regulation of load
compartment temperature (optional feature):
Cooling temperature can be selected between 0 – 12°C
(32 – 54°F).
■
Deep frozen produce transport system:
Cooling temperature can be selected between -20 – 40°C
(-4 – 104°F).
To Next Page
Loading...
Need help?
General
