17
Press the control knob within 5 seconds in
order to confirm selection.
* depending on the installed heater.
4.3.5 Adjusting the remaining operation time during functioning
3
The heater is in the heating mode.
Press the control knob in order go from tem-
perature selection to heating mode selection.
Press the control knob in order go from
heating mode selection to remaining operation
time selection.
Turn the control knob in order to adjust remai-
ning operation time.
By means of turning the control knob in
anticlockwise direction one can shorten remaining
operation time.
If longer remaining operation time is desired then
longer remaining operation time must be reset.
Press the control knob within 5 seconds in
order to confirm selection.
To Next Page
Loading...
