Webasto Thermo Top Evo 5+ - Preparing Installation Location; Detaching bracket; Hole in frame side member; Installing heater

Mercedes Benz C-Class S204, W204, C204 / GLK-Class X204
Ident. No.: 1315959G_EN Status: 31.01.2013 © Webasto Thermo & Comfort SE
14
Preparing Installation Location
Figure shows W204 with daytime running
light.
Loosen original vehicle bolt at position
2, 3
and
5. Insert large diameter washer at posi-
tion
5 between bracket 4 and bumper. Tighten
bolts at position
3 and 5.
Bend twist protection at position
1 toward
rear. Twist cylinder of the headlight washer
system and fix with cable tie (observe dis-
tance between connector of front fog light, if
available, and bracket of heater).
Detaching
bracket
Remove joint sealer in the area of the holes 1
or 2 on the inner side of the frame side mem-
ber.
C204, S204 and W204
1
7 mm dia. hole
X204
2
7 mm dia. hole
Hole in
frame side
member
Figure shows W204 with daytime running
light.
Mount heating bracket
3 with oblong hole be-
tween detached bracket
2 and bumper at po-
sition
1.
1 Original vehicle bolt
Installing
heater
C204, S204 and W204
When drilling, watch components located be-
hind.
1 M6x20 bolt, flanged nut
Loosely
mounting
heater
22
2
3
5
4
1
23
2
10
10
35
1
24
2
1
3
25
1