8 | Unite Configuration Interface
22 / 37 5111967A OI-II Webasto Unite
8.4 OCPP Settings
OCPP Connection
If you set the OCPP Connection mode to “Enabled” then you
must complete all fields in the connection settings section and
enable the configuration parameters sections.
Currently, the only available OCPP version is OCPP 1.6, so this is
selected by default.
Click the Set to Defaults button to reset OCPP configuration
parameters.
You can select the following OCPP settings type from the menu
on the left of the page:
– OCPP Connection
– OCPP Version
– Connection Settings
– OCPP Configuration Parameters.
Click the Save button to apply your selection.
Please note that the system does not accept the unsuitable val-
ues and will return a warning. In this case, values will not be
saved, after which you are then returned to the main page; so
check your values.
If you make any changes, and you do not save these before
leaving the page, then the below warning will be returned.
8.5 Network Interfaces
You can configure Ethernet and Wi-Fi on this page.
To activate an interface mode, set it to “Enabled”.
If you set IP setting to "Static", blank spaces are mandatory for
the fields "IP Address", "Network Mask", "Default Gateway"
and "Primary DNS".
If you enable Wi-Fi, then “SSID”, “Password” and “Security” are
mandatory.
Complete all spaces in the suitable format.
LAN
WLAN
Click the Save button to finish.
WIFI HOTSPOT
For details, see chapter7.3, "Accessing the Unite configuration
interface via Wi-Fi hotspot" on page 19.
WARNING
If you change the SSID and Password of the WIFI Hot-
spot, the QR Code for the Webasto Charger Setup App
will not work anymore – you must enter the credentials
manually after changing these settings.
Here you can configure the behaviour of the WiFi Hotspot:
To Next Page
Loading...
Need help?
General
