Weber mt CR 5 - Maintenance Schedule Overview; Initial Maintenance (25 Hours); Daily;Frequent Maintenance (8 Hours); Periodic Maintenance (150 Hours;6 Months;Year)

CR5 15
Maintenance overview
In addition to the aforementioned maintenance work, the engine manufacturer’s regulations must
be complied with.
Work must be carried out using regulation tools and the operating and maintenance manual must
be complied with for all work.
All maintenance work: select a collection vessel that is large enough to prevent oil from spilling onto
the ground. Dispose of waste oil in an environmentally friendly manner (regulation on waste oils).
Dispose of oils, oil-soaked cloths, and parts replaced and smeared with oil in an environmentally
friendly manner.
If lubricating oils and fuel come into contact with skin, they can cause skin cancer. Upon contact
with the skin, clean affected skin with suitable cleaning agent without delay.
If accessible during maintenance, check the condition and stability of all screws.
Maintenance interval
Maintenance
point
Maintenance activity
After the rst 25
operating hours
Engine
- Change engine oil
-
Check valve clearance,
adjust if necessary
-
Re-tighten all accessible
threaded connections
Every 8 operating
hours/daily
Air lter -
Clean air lter insert,
check for damage,
replace if necessary
Every 150 operating
hours/every 6 months
Engine - Change engine oil
- Change the fuel lter
- Change oil lter
Every 150 operating
hours/every year
Transmission - Change oil
Exciter - Change oil
Every 250 operating
hours
Engine -
Check valve clearance,
adjust if necessary