Weber mt CR 5 - Engine Maintenance Procedures; Changing Engine Oil; Engine Oil Filter Cleaning;Replacement

16 CR5
Cleaning the engine oil lter
Changing the engine oil
1
Open the cover lid (1) of the oil ller neck.
1
When working in the area of the engine compartment
there is danger of burn injury!
Screw the oil drain pipe (1) onto the engine drain valve and
drain off the oil.
After emptying completely, unscrew the oil drain pipe
from the drain valve and ll with oil in accordance with the
specication.
Loosen the screw (1) approximately 5 revolutions.
Pull the oil lter (1) out of the motor compartment.
Blow out the oil lter (1) from inside to outside with
compressed air.
Lightly oil the sealing rings (2) on both sides of the oil lter.
Check sealing rings (2) for damage and rm seat, replace
the oil lter if there is damage.
Press the oil lter into the crankcase until the stop.
Prior to tightening the screws ensure that the tension
springs rest on the oil lter with both ends „1“.
1
Drain engine oil.
Maintenance work
Only drain engine oil when at operating temperature.
Danger of scalding due to hot oil.
Danger of scalding due to hot oil.
Only drain engine oil when at operating temperature.