EasyManua.ls Logo

Weber mt SRV 590 - Starting the Engine

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SRV 590 13
1
2
1
1
1
When starting in enclosed spaces ensure adequate
ventilation – danger of suffocation.
Never use any starter spray.
The engine is equipped with an oil monitoring system.
If the LED (1) is illuminated during the start process, you
must interrupt the start process and check the oil level.
Top off with oil as specied if the oil level is too low.
Starting
After horizontal transport: Bring tamper into a vertical
position and wait several minutes until the engine oil
has collected in the lower area of the crankcase.
Bring the gas lever into full-throttle lock-in position.
Open the fuel cock (1).
Push the choke lever (1) to the right (close).
Slowly tighten the handle (1) of the reversing starter (2) until
resistance is noticeable.
Allow the handle (1) to glide back into the initial position, and
then forcefully and completely pull it through with both hands.
Allow the engine to warm up for a few minutes.
After the engine has warmed up, slide the choke lever to
the left (open).

Related product manuals