14 SRV 590
1
1
1
Tamping
Bring the gas lever into the / l ock-in position.
Compacting is only permissible at gas lever position
/ as there is an increase level of wear in the
slip range of the centrifugal clutch.
At obstructions (walls, pits, etc.) ensure that no one can
be caught between the machine and the obstruction;
or ensure that the machine does not slip into the pit.
Only run machine within reach of the manual guidance
rod (1).
Unauthorized persons are forbidden from being in the
area of the tamper during the compacting process.
Shutting down
Bring the gas lever to the “min.” (1) lock-in position.
Do not switch off the engine under full load; let engine
run idle for a few minutes.
Close the fuel cock (1).
To shut off the engine push the gas lever back beyond the
idle lock-in setting (0/OFF)
During breaks – even if they are short – the machine
must be shut down.
Parked devices that represent an obstacle must be
safeguarded against through conspicuous measures.
To Next Page
Loading...
