Weber mt SRV 590 - Maintenance Overview

SRV 590 15
Maintenance overview
Maintenance interval Maintenance point Maintenance activity
After the rst 10
operating hours
Engine
- Change engine oil
-
Check valve clearance,
adjust if necessary
-
Re-tighten all accessible
threaded connections
Every 50 operating
hours/every 6 months
Main air lter -
Clean air lter insert,
check for damage,
replace if necessary
Engine
- Change engine oil
- Change the fuel lter
Every 150 operating
hours
Secondary air lter
Engine
-
Clean socondary air
lter, check for damage,
replace if neccessary
-
Check valve clearance,
adjust if necessary
Every 150 operating
hours/every year
Tamping system - Change oil
The regulations of the engine manufacturer must be complied with in addition to the above
maintenance overview!
Work must be carried out using regulation tools, and the operating and maintenance manual
must be complied with for all work.
All maintenance work: select collection vessels large enough to prevent oil from spilling onto the
ground. Dispose of waste oil in an environmentally friendly manner (regulation on waste oils).
Dispose of oils, greases, cloths soaked in oil, and replaced parts with oil on them in an envi-
ronmentally friendly manner.
If lubricating oils and fuel come into contact with skin, they can cause skin cancer. Upon contact
with the skin, clean affected skin with suitable cleaning agent without delay.
If accessible during maintenance, check the condition and stability of all screws.