EasyManuals Logo

Weber Q Series User Manual

Weber Q Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30 WWW.WEBER.COM
Summary lighting instructions are posted on
the cart leg under the burner control knobs.
BURNER IGNITION
A) Open the barbecue lid (1).
m DANGER
Failure to open the lid before igniting
the barbecue’s burners, or not waiting
five minutes to allow the gas to clear if
the barbecue does not light, may result
in an explosive flare-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned
off(2). Check by pushing burner control knobs in and
turning them clockwise until they stop.
C) Turn gas supply on at source.
D) Light the outside burner by pushing the large burner
control knob in and turning it counterclockwise to
start/high ( ) position (3).
E1) Push the red igniter button several times, so it clicks
each time (4) (Q 3100).
OR
E2) Push and hold in the electronic igniter button (5)
(Q 3200). You will hear the igniter clicking.
F) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
m WARNING: While igniting the barbecue
or cooking, never lean over open
barbecue.
m WARNING: If the burner fails to ignite
within five seconds, stop, turn the burner
control knob to off and wait five minutes
to allow the gas to clear before you try
again or light with a match.
G) After the outside burner is lit, you can turn on the
inside burner. Push in the small burner control knob
and turn it to start/high ( ) position (6). The inside
burner will then be ignited by the outside burner.
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
BURNER IGNITION & USAGE
METHODS OF BURNER
IGNITION
There are two ways to ignite
the burner. The first is by using
the ignition system built into
your barbecue. The second is
with a match.
Next are the steps for
igniting your barbecue using
the ignition system. On the
following page are steps for
igniting your barbecue with a
match.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your barbecue. Do not confuse
this plastic with the battery
label.
1
5
4
2
3
6

Other manuals for Weber Q Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Weber Q Series and is the answer not in the manual?

Weber Q Series Specifications

General IconGeneral
Main Burners1
Lid MaterialCast Aluminum
Burner MaterialStainless Steel
BTU-per-hour Input8, 500 BTUs
Ignition SystemElectronic
Grate MaterialCast iron
Fuel TypePropane
Warranty5 years

Related product manuals