Weber SRV 66 - Starting the SRV 66

SRV62_66 15
2.5.2 Starting the SRV 66
- Turn the stop button (11/1) to the right into the „On“
position.
- Put the fuel stop cock (12/1) into the vertical position
to open it.
- Open or close the choke (13/1) according to the
engine and/or ambient temperature.
- In case of a cold engine and/or low ambient
temperatures, totally close the choke (13/1). Turn
the choke to the right side as far as possible.
- In case of a warm engine and/or high ambient
temperatures, open the choke (13/1) half to all the
way (choke to the left side).
- Slowly pull the handle (14/2) of the reversible
starter (14/1) until a resistance is felt.
- Let the handle (14/2) recoil into its original position
and then firmly pull the cable with both hands to
start the engine.
Important!
If the engine should fail to start, repeat the
starting procedure.
- As soon as the engine starts, let the starter cable
recoil into its housing (14/1).
- Slowly bring the choke (13/1) into the fully open
position (choke to the right side) and let the engine
idle for warming up.
- Put the speed adjusting lever (11/2) into the full
speed position.
Figure 13
Figure 12
Figure 14
Figure 11
1
2
1
1
1
2
RAMIRENT