SRV62_66 27
4 Malfunctions During Operation
4.1 General
If a malfunction occurs on the tamper, proceed as follows:
- Put the tamper out of operation as described in paragraph 2.7.
- Determine the source of the malfunction (refer to paragraph 4.2 - Trouble Shooting).
- Eliminate the malfunction (refer to paragraph 3 (maintenance work) and paragraph 2 (description of the
various controls).
Please refer to the manual of the engine manufacturer with regard to the repair of engine
malfunctions.
The detailed description of the various controls and the references given in the column "Remarks/Notes"
of the maintenance survey chart (paragraph 3) and trouble shooting chart (paragraph 4.2) allows a quick
failure elimination on condition that the given order is precisely kept to when service work is carried out.
Any service work has to be made with appropriate tools and in accordance with the safety
regulations set out in this operating and maintenance manual.
If a problem persists although a component or assembly group has been replaced, repair work has to be
continued with the work described next. If a failure cannot be rectified although the described service work
has been carried out or if a defect is not described in the operating and maintenance instructions, the failure
must be repaired by authorized service personnel.
To Next Page
Loading...
