Weber Summit 4 BURNER - Lighting; Crossover Ignition System

6
LIGHTING
EACH HEAT ZONE OPERATES INDEPENDENTLY.
Summary lighting instructions are on the control panel.
Crossover Ignition System
Note - The Crossover Ignition System ignites the Left
burner of each heat zone with a spark from the igniter
electrode inside the Gas Catcher Ignition Chamber.You
generate the energy for the spark by pushing the
Crossover Ignition Button until it clicks.
WARNING: Check hose before each use of barbecue
for nicks, cracking, abrasions or cuts. If the hose is
found to be damaged in any way, do not use the
barbecue. Contact your dealer.
WARNING:The storage space under the cooking
module is intended for storage of nonflammable
items only.
Figure 1
DA N G E R
Failure to open lid while igniting the
b a r b e c u e, or not waiting 5 minutes to allow
the gas to clear if the barbecue does not light,
m ay result in an explosive flame-up which
can cause serious bodily injury or death.
High Medium Low Off
Crossover Ignition System
Summit 425 or 450
Crossover Ignition System
Summit 625 or 650
Crossover Ignition System
Summit 475
Crossover Ignition System
Summit 675
1 ) Open the lid. Figure 1.
2) Make sure all burner control knobs are OFF. (Push
each burner control knob down and turn clockwise.)