56589 10/30/11
AA
NOTE: Grills illustrated may have slight differences than model purchased.
THIS PROCEDURE SHOULD ONLY BE PERFORMED BY AN AUTHORIZED
WEBER-STEPHEN PRODUCTS LLC SERVICE TECHNICIAN
WARNING: GENUINE WEBER-STEPHEN REPLACEMENT PARTS MUST BE USED FOR ANY REPAIR OR REPLACEMENT.
YOUR ACTIONS, IF YOU FAIL TO FOLLOW THIS PRODUCT WARNING, MAY CAUSE A FIRE, AN EXPLOSION, OR
STRUCTURAL FAILURE RESULTING IN SERIOUS PERSONAL INJURY OR DEATH AS WELL AS DAMAGE TO PROPERTY.
(WILL VOID ALL WARRANTY PROTECTION.)
DANGER: BEFORE PERFORMING ANY WORK MAKE SURE THE GAS SUPPLY IS TURNED OFF AT THE SOURCE.
FAILURE TO FOLLOW DANGERS, WARNINGS AND CAUTIONS CONTAINED IN THIS INSTRUCTION SHEET MAY CAUSE A
FIRE OR AN EXPLOSION RESULTING IN SERIOUS PERSONAL INJURY OR DEATH AS WELL AS DAMAGE TO PROPERTY.
REAR VENT ASSEMBLY
REPLACEMENT INSTRUCTIONS
ReaR
FilleR StRip
Replacement
BEFORE STARTING:
Make sure lid is closed
and casters are locked to
prevent grill from moving.
1
DiScOnnectiOn OF GaS SOURce
2
FilleR StRip RemOVal
A) Remove all front, side, and rear filler strips.
ReaR
Vent
Replacement
ReaR
Vent bRacket
Replacement
1
1
A) Make sure main gas source is completely turned off.
B) Located inside tank enclosure, disconnect main corrugated gas line from
bulkhead fitting, (1).
C) Pull main corrugated gas line through
island structure cavity and into grill
assembly. (Not Pictured)
To Next Page
Need help?
General
