SERVICE AND ADJUSTMENTS
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 29)
The throttle control has been preset at the factory and
adjustment should not be necessary. If adjustment is
necessary, proceed as follows:
• With engine not running, move remote throttle control
lever to "FAST" position.
• If throttle lever on engine touches high speed stop, no
further adjustment is necessary. If throttle lever does
not touch high speed stop, continue with adjustment
procedure.
• Loosen cable clamp screw.
° Move throttle lever up until it touches high speed stop,
and hold in this position.
Tighten cable clamp screw securely.
THROTTLE
CABLE
SPEED STOP
CABLI
CLAMP
SCREW
LEVER
FIG. 29
TO ADJUST CARBURETOR
Thecarburetorhasbeen preset atthefactoryand adjustment
should not be necessary. However, engine performance
canbe affected by differences infuel, temperature, altitude
or load. If the carburetor does need adjustment, contact
your nearest authorized service center/department
IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVERSPEEDINGTHE ENGINE ABOVETHE FACTORYHIGH
SPEED SETFING CAN BEDANGEROUS. IFYOU THINKTHE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACTYOURNEARESTAUTHORIZEDSERVICE CENTER/
DEPARTMENT,WHICH HASTHE PROPER EQUIPMENT AND
EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.
18
To Next Page
Loading...