TECHNICIANS' manual 5 of 100
• Do not place your hands or other body
parts near the steam, hot water or milk
dispensing nozzle tips.
If gas is used (where applicable), take spe-
cial care with the following:
• When indoors, always provide air vents.
• Check for any gas leaks.
• Do not under any circumstances at-
tempttolightthegaswithoutrst
installing the proper injector.
• Do not start up the gas burners when
the heating unit is empty.
Only perform the maintenance and clean-
ing operations indicated in this manual.
If the problem cannot be resolved, switch off
the machine and contact the Manufacturer.
All maintenance operations must be carried
out when the power supply has been turned
off, the water mains has been closed off, and
the machine has completely cooled down.
After maintenance and/or repair work, the
components that are used must ensure
that the hygiene and safety requirements
initially provided for the appliance are still
met. These are met by only using origi-
nal spare parts. When components which
come into contact with water or food are
repaired or replaced, a washing procedure
hastobecarriedout,asifitweretherst
installation.
The Technician must inform the User
about the methods of periodic te-
sting of pressure equipment and safety de-
vices in accordance with the legislation in
force in the country of installation.
I.VI. EMERGENCY SITUATIONS
Should an emergency situation occur as a
result of a machine malfunction, adopt the
measures provided for in the emergency
plan posted in the premises and in any case,
proceed to immediately carry out the ac-
tions based on the type of problem.
SHORT CIRCUIT FIRE
In the event of a re caused by the ma-
chine’s electrical system malfunctioning,
adopt the following behaviours:
• Disconnect the machine from the
power mains via the main switch.
• Callthereandrescueservice.
• Get everyone a safe distance away
from the premises.
• ExtinguishtheamesusingaCO
2
re
extinguisher.
GAS LEAK
In the event of a re caused by the ma-
chine’s system malfunctioning, adopt the
following behaviours:
• Shut off the gas supply by closing the
valve upstream of the machine.
• Get everyone a safe distance away
from the premises.
• Ventilate the premises.
• Call the technician that installed the
machine.
• Ifnecessary,callthereandrescue
service.
GAS LEAK FIRE
In the event of a re caused by the ma-
chine’s gas system malfunctioning, adopt
the following behaviours:
• Shut off the gas supply by closing the
valve upstream of the machine.
• Disconnect the machine from the
power mains via the main switch.
• Callthereandrescueservice.
• Get everyone a safe distance away
from the premises.
• ExtinguishtheamesusingaCO
2
re
extinguisher.