Weider 1120 - Page 12

18, Locate the Low Cable (53). Route the CaMe
through the Leg Lever (8) and the Front Leg (7),
Attach a 90mm PuHHey(48) inside of the Leg
Lever (8), over the Low CaMs (53), with an MIO x
67mm BoHt(71), two MIO Washers (57), two
12mm Spacers (52), and an MIO NyHonLocknut
(56),
19, Attach a 90mm PuHHey(48) inside of the Front Leg
(7), over the Low CaMe (53), with an MlO x
67mm BoHt(71), two MIO Washers (57), two
12mm Spacers (52), and an MIO NyHonLocknut
(56),
20, Route the Low CaMs (53) under a 90mm PuHHey
(48) and through the Upright (3), Attach the PuHHey
inside of the upright with an MIO x 67mm BoHt
(71), two MIO Washers (57), two 12mm Spacers
(52), and an MlO NyHonLocknut (56),
21, Route the Low CaMe (53) over a 90mm PuHHey
(48), Attach the PuHHeyand two HaHfFinger
Guards (43) to the Double "U"-Bracket (63) with
an MIO x 48mm BoHt(81) and an MIO NyHon
Locknut (56), Make sure the Finger Guards are
on the outside of the "U"-bracket as shown,
18
19
2O
21
57
5_52
56
57
53
52
71
57
52 _
/
71
52
71
63
12