1
Before beginningassembly,makesureyou
understandtheinformationin the box on
page 5. Refer to the PART iDENTiFiCATiON
CHART in the center of th!s manual for help
identifying small parts.
Unserttwo M10 x 65mm Carriage BoUts(78) and
two M8 x 63mm Carriage BoUts(87) up through
the Base (1), Note: It may be helpfut to ptace a
piece of tape over the bott heads to hotd them
in place.
Attach the Base (1) and the two Weight Guides
(21) to the Stabilizer (2) with two MIO x 67mm
BoUts(71), two MlO Washers (57), and two MlO
NyUonLocknuts (58), Make sure the indicated
holes in the Weight Guides are nearer the bot-
tom.
Attach the Upright (3) to the Base (1) with the two
MlO x 65mm Carriage BoUts(78) and two MlO
NyUonLocknuts (58), Do not tighten the
Locknuts yet.
78
87
21-
71
78
71
6
To Next Page
Loading...
