34, Attach the CurUPad (14) to the CurUPost (13) with
two M6 x 16mm Screws (62),
34
14
Ii _'I
35, Make sure that aHparts have been properUy tightened, The use of the remaining parts wHUbe expUained in
ADJUSTMENTS, beginning on the following page,
Before using the weight system, pull each came a few times to make sure that the caMes move smootHy
over the pulleys, If one of the caMes does not move smootHy, find and correct the proMem, IMPORTANT: If
the eabJes are not properly installed, they may be damaged when heavy weight is used, See the
CABLE DIAGRAMS on page 20 of this manual for proper cable routing, If there is any slack in the
cables, you wilt need to remove the slack by tightening the cables, See MAINTENANCE on page 21,
16
To Next Page
Loading...
