61. Turn the Squat Backrest (35) so that the four screw
holes are closer to the bottom of the Squat
Backrest than the top. Attach the Squat Backrest to
the Squat Bracket (37) with four M6 x 16mm
Screws (114).
Turn the Adjustment Knob (115) counterclockwise
several times to loosen it. Next, pull the Knob and
slide the Squat Bracket (37) down onto the Squat
Slider (38). Engage the Knob into one of the holes
in the Squat Slider, and then turn the Knob clock-
wise until it is tight.
62. Attach the Curl Pad (11) to the Curl Post (12) with
two M4 x 16mm Screws (114).
61
37
114
62
114
63. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 22 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in
the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING on
page 25.
21
To Next Page
Loading...
