WeiderPro Pro 4500 - Page 16

16
17. Apply grease to an M8 x 19mm Shoulder Bolt
(65). Attach the Arm Cable (54) to the indicated
Cable Pivot (39) with the Shoulder Bolt and an
M8 Locknut (58). Make sure that the Cable
c
an pivot freely around the Shoulder Bolt.
17
58
6
5
54
39
G
rease
18. Identify the High Cable (55). Route the High
Cable up through the Top Frame (4) and over a
90mm Pulley (48). Attach the Pulley inside of
the Top Frame with an M10 x 80mm Bolt (71),
two M10 Washers (57), two 19mm Spacers
(33), and an M10 Locknut (56).
19. Route the High Cable (55) over a 90mm Thin
Pulley (47) and down through the Top Frame
(4). Attach the Thin Pulley inside of the Top
Frame with an M10 x 80mm Bolt (71), an M10
Washer (57), and a 19mm Spacer (33). Make
sure that the Thin Pulley does not fall out of
the Top Frame while you complete steps 20
and 21.
18
19
56
4
55
33
33
57
57
48
71
4
55
33
57
47
71