58
January, 2017
TEST SETTINGS
The test settings section allows you to view your settings in operations before saving them to the
database. This will allow you to view the effect each setting will have on the head sequence. Take note
that you will not be able to use these buttons if the PrimoCombi is in RUN or PAUSE mode.
Write Values to Primo – Clicking this button will send the current values for the center cone
vibrator settings to the PrimoCombi.
Test Center Cone – This will activate the center cone vibrator.
Unless you are an advanced operator it is suggested that you test your settings prior to saving them.
To Next Page
Loading...
