11.4 Setup menu
Parameters Scale settings
Dump settings Settings that control the automatic dump cycle operation
I/O test Test input and output modules
Info menu Troubleshooting features
Clock Set time/date
Contrast Control display intensity
11.5 Parameters
Setup units
Setup units: used for entering capacity and resolution (defaults to
pounds)
Capacity Scale capacity, in setup units
Resltn Scale resolution, in setup units
Stability Number of consecutive readings required for stability
Motion sns
Number of divisions allowed before weight is considered unstable
AZT On/Off: Autozero tracking on/off, only affects weights near zero
AZT band Amount of weight (in divisions) that can be zero tracked out
Calibrate Start calibration routine
IZ set Set initial zero at power up (default to off)
lb units On/Off: Enables the units toggle key to include pound units
kg units On/Off: Enables the units toggle key to include kilogram units
g units On/Off: Enables the units toggle key to include gram units
oz units On/Off: Enables the units toggle key to include ounce units
Filter
Weighing filter speed: range of 0-0.9. Larger numbers make the
filter slower, but weights are more stable
Address Communications/scale address
Cntst Enabled/disabled: Three key quick contrast feature
IR lock When turned on, the Palm is required to access the setup menus
Defaults Restore scale to factory default settings (all settings will be lost!)
17
To Next Page
Loading...