To unlock the keypad, you must play follow the leader. One key will be lit. Press
it. Another key will then light up. Press it. Continue until the indicator displays “Exit
washdown”. The indicator will require that you press five keys in a row correctly before
it will unlock the keypad. Any wrong keypress will restart the counter back to five. The
odds are extremely slight that random water splashing would ever be able to trigger the
correct keys in the correct order to unlock the keypad.
3 Main menu items
3.1 “Power off”
Touch the enter key to select this menu item, which will power down the indicator. If
the auto-on jumper is installed on the interface board, the indicator will immediately
turn back on.
3.2 “Washdown”
This function puts the indicator in washdown mode to prevent inadvertent keypad
activity. See the washdown section of this manual for more information.
3.3 “Totals”
This function leads to the totals submenu.
3.4 “Calibrate”
This function allows you to calibrate the scale. Refer to the calibration section of this
manual for details.
3.5 “Setup Menu”
Enter the setup submenu, where scale parameters can be viewed or set.
3.6 “Audit cfg”
Displays the audit counter for configuration. Every time a sealed scale parameter is
modified this counter will increment by one. This setting is nonvolatile (it will be
retained even if the batteries go dead) and cannot be altered except by modifying an
audited configuration parameter.
3.7 “Audit cal”
Displays the audit counter for calibration. Every time the scale is calibrated this counter
will increment by one. This setting is nonvolatile (it will be retained even if the batteries
go dead) and cannot be altered except by performing a calibration.
5
To Next Page
Loading...