WeighTech MicroWeigh - General Scale Operation Procedures; Scale Startup and Shutdown Procedures; Zeroing and Unit Selection

• Press the “Menu/Help” key
• Scroll through the main menu using the up or down arrow keys until “Calibrate *”
is displayed on the indicator
• Press the “Enter” key to start the calibration routine
• The indicator may display “Password” if a calibration password is required. If so,
enter it (default calibration password is “Zero” “Zero” “Zero”)
• The indicator should now be displaying “Cal Weight” and a blinking cursor.
• Press the up arrow key. The display should now show “Cal weight 1”
• Press the up arrow key again. The display should now show “Cal Weight 2”
• Press the right arrow key to accept the first digit (2) and advance the blinking
cursor to the next digit. The indicator should display “Cal weight 2 ”
• Press the up arrow key five times to select a 5 as the second digit. The indicator
should now display “Cal weight 25”
• Press the “Enter” key to accept 25 pounds as a calibration weight.
• The indicator will display “Cal–zero weight”. Press the “Cancel” key to abort the
calibration process.
4.3 How to select from a list
This is very much like stepping through a menu. Some settings (such as displayed
resolution) must be limited to one of several predetermined values. To edit one of these
settings, press the “Enter” key. The currently selected value will move from the far right
of the display to the left. This indicates that you may use the up and down arrow keys to
scroll through a list of possible values for this setting. Once you’ve selected a value for
the setting, press the “Enter” key to complete the selection process. As always, pressing
the “Cancel” key will cancel the selection and restore the setting to the previous value.
5 General Scale Operations
5.1 Scale On Procedure
Touch the “Zero / On” key. Indicator will come on and display will read “MicroWeigh
by WeighTech” and then continue to the weigh mode. At this point the scale is ready
for product or operator input.
5.2 Scale Off Procedure
To turn the scale off touch the “Menu / Help” key. The indicator will display “Power off
*”. At this point touch the “Print / Enter” key and scale display will go blank, and the
indicator will be off.
7