It refers to the maximum angle deviation between snapping and template. If actual
deviation exceeds this value, shooting may fail.
3. Click Apply to activate parameter settings and click OK.
Measuring Distance and Angles
Use Measure function to measure the distance or angle between two specified
points.
Steps
1. Move the machine axes to one point, and click Measure 1.
2. Move the machine axes to another point, and click Measure 2.
The system will calculate the results.
Note that the angle refers to the angle relative to the positive
direction of X-axis.
Preparing Toolpath
At present, CCD system supports two kinds of working modes:
• General engraving mode
No marking points or shooting points are needed. The system is used as a
general engraving control system.
• Machining with marking points
– Retrieving toolpath from a .jpg file
– Importing toolpath from a .dxf file
Retrieving Contour from JPG File
By setting related parameters, the control system can automatically retrieve contour
from a JPG file.
Do the following to retrieve contour from a JPG file.
Steps
1. Launch NcStudio, and switch to NcEditor interface.
2. Click File → Import JPG file…. A dialog box named Open opens.
3. Select the target .jpg file. A dialog box named Contour Param opens.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
To Next Page
Loading...
Need help?
General