WEIHONG ELECTRONIC NcStudio V10 CCD System - CCD Commissioning; Commissioning Steps; Setting CCD Related Parameters

CCD Commissioning
To make CCD ready for machining, you need to adjust the camera and do some
commissioning.
Follow steps below to do the commissioning.
1. Power up and start the NC system.
2. Turn the system to Homing mode, and return all machine axes to the machine
origin.
3. Turn the system to Manual mode, Click Vision → CCD → Parameters →
Manufacturer Param → Measure to switch to Measure interface.
4. Use the function Pick Current to decide the working plane.
It is recommended to leave distance between the camera bottom to the
workpiece surface 125mm.
See Setting CCD Working Plane for details.
5. Adjust the camera, including the focal length, aperture, etc. to ensure the
camera can get a clear sight.
6. Measure the magnification of the camera.
7. Move to the shooting position.
8. Camera shoots and gets marking points.
Setting CCD Related Parameters
To make CCD ready for machining, you need firstly set related parameters, including
parameters of different access.
Prerequisite
All machine axes have returned to the machine origin.
Steps
To set CCD related parameters:
1. Click Vision → CCD → Parameters. It opens dialog box titled "Machine Vision
Parameter".
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
- 10 -