WEIHONG ELECTRONIC NcStudio V10 CCD System - Setting Layer and Parameters; Convert DXF File to Toolpath

Deciding Active Objects
To decide the contour will be machined or not this time.
Steps
Do the following to decide the contour or object to be machined or not.
1. Turn to NcEditor interface and select the contour.
2. Right click on the contour, and select Not to machine menu on the pop-up list.
When machining starts, this contour will be skipped.
3. (Optional) Right click on the selected contour, and select Machine menu on the
pop-up list. When machining starts, this contour will be machined as required.
Setting Layer and Parameters
NcEditor takes objects that have the same parameter settings as a layer by default.
Each layer is represented in a color. That is, if you modify a parameter of one layer
in one color, the parameter setting of all objects in this layer will be updated.
Convert DXF File to Toolpath
A DXF file can be directly imported to the system and converted to toolpath.
Steps
1. Prepare DXF file.
1. Draw in AutoCAD or other drawing software.
2. Add marks to the objects.
3. Save the drawing as .dxf file format.
2. Launch NcStudio, and switch to NcEditor interface. Click File → Import DXF
file to import the prepared .dxf file into NcEditor.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
- 34 -