Focal Level
It sets the height in Z-axis when the camera takes clear photos.
Pre-shoot delay
It sets the delay time to stabilize the camera before taking a photo.
Post-shoot delay
It sets the delay time after the camera takes a photo.
Shoot times
It sets how many times the camera takes photos at a shooting position.
4. Click Developer on the left side, and set parameters of developer’s access on
the right.
• Click Snap image button to take photos at current position.
• It is recommended to check the box Scaling for Three-point shooting.
Setting CCD Working Plane
CCD working plane refers to the XY plane at focal height. To set the working plane is
to set the focal height in Z-axis.
Prerequisite
Well adjust focal length and aperture of the camera lens. See camera lens for details.
Steps
1. Turn the system to Manual mode, Click Vision → CCD → Parameters →
Manufacturer Param → Measure to switch to Measure interface.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
To Next Page
Loading...