4. Setting lead lines.
5. Deciding active objects.
6. Setting in-process parameters.
Setting Workpiece Origin
After contour is retrieved and has been imported it into the system, a default
workpiece origin will be defined at the lower-left of the contour.
See figure below for default workpiece origin.
Do one of the followings to modify the workpiece origin.
• Click Draw → Set Origin and set the workpiece origin in the pop-up dialog box.
– (Recommended) Select the position of the marking point that will be
used as the workpiece origin.
– Directly enter X, Y coordinates of the workpiece origin.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
To Next Page
Loading...