After the workpiece origin is defined, the system can know workpiece coordinates
of each marking point.
Setting Machining Direction
Before you begin, import the contour that has been retrieved into the system.
Do the following to set machining direction.
1. Turn to NcEditor interface, and click show/hide machining direction icon
on the tool bar.
2. Select the contour whose machining direction needs to be set in the drawing
area.
3. On the Property pane, check the setting of Direction parameter.
– If Direction parameter has been checked already, uncheck it.
– If Direction parameter has not been checked, check it.
4. Check the machining direction in the drawing area.
Example:
See figure below for how to set machining direction.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
To Next Page
Loading...