WEIHONG Ncstudio V15 User Manual

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
26 / 116
 P1-01 Control mode setting
o Description: Control mode setting
o Unit: -
o Format: YX1X0
 Y=0: Rotates CW (anti-clockwise when observing from the load side).
Y=1: Rotates CCW.
 X1X0=00: The control mode is position control.
o Range: -
o Value: 000
 P1-32 Motor stopping mode
o Description: Motor stopping mode
o Unit: -
o Format: YX
 Y=0: When the servo motor is disabled, dynamic braking is used. Y=1:
When the servo motor is disabled, the motor moves freely.
 X=0: The motor is stopped instantly. X=1: The motor decelerates
before stops completely.
o Range: -
o Value: 00
 P1-44 Electronic gear ratio numerator N1 and P1-45 Electronic gear ratio
denominator M
o Description: Relation between P1-44 and P1-45
o Unit: -
o Format: -
o Range: 1–32767
o Equation: P1-44/P1-45 = (Encoder resolution × pulse equivalent ×
mechanical reduction ratio)/screw pitch.
o Value: When the encoder pulse number = 2500, pulse equivalent = 0.001,
screw pitch = 5 mm, and mechanical reduction ratio = 1,
N1/M=2500×4×0.001/5=2/1. Therefore, N1=2 and M=1.
 P2-10 Digital input pin DI1 function setting
o Description: Digital input pin DI1 function setting
o Unit: -
o Format: X2X1X0
 X1X0=01: Set digital input DI1 to SON, matching pin No.17 of CN1.
 X2=1: Set input DI1 to the normally open contact a.
o Range: -
o Value: 101
 P2-15 Digital input pin DI6 function setting
o Description: DI6 is NC position limit signal input by default. The drive cannot
work before the CN1 pin No.32 and pin No.31 are connected.
o Unit: -
o Format: X2X1X0
 X2=1: Set input DI6 to the normally open contact a.
 X1X0=00: Drive position limit input was not used.
o Range: -
o Value: 100
 P2-18 Digital output pin DO1 function setting
o Description: DO1 pin is pin No.16, which is used for Z-axis clamping position
braking signals.

WEIHONG Ncstudio V15 Specifications

General

Brand	WEIHONG
Model	Ncstudio V15
Category	Control Systems
Language	English