WEIHONG Ncstudio V15 - 4.3.2 Follow Setting; 4.3.3 Follow-up

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
51 / 116
 Follow Height
o Description: Indicates the distance between the cutter and material plate
during follow control.
o Range: 0 mm–30 mm
o Value: 1
 Z UP Pos.
o Description: Indicates the mechanical coordinate you want the Z axis to stop
at after the Z axis go to the mechanical origin and the follow/machining is
complete.
o Range: -100 mm–100 mm
o Value: -10
 Safe Lift Height
o Description: Indicates the safe lift height of the Z axis when it is not at the
mechanical origin.
o Range: 0 mm–100 mm
o Value: 40
 Follow Max.H.
o Description: Indicates the maximum direct follow height.
o Range: 0.01 mm–16 mm
o Value: 5
4.3.3 Follow-up
Includes the following parameters:
 Positioning Gain
o Description: Used to control the sensitivity of positioning movement during
follow
o Range: 1–20
o Value: 8
 Follow-up Gain
o Description: Used to control the follow sensitivity.
o Range: 1–5
o Value: 1
 Follow-up feed forward
o Description: During a certain range, the larger this value, the quicker the
response. If this value is too larger, jitters will be created during follow.
o Range: 0–100
o Value: 50
 INposition Tolerance
o Description: When the system detects that the current height = follow height
± in position tolerance, the system thinks that the cutter has moved to the
follow position.
o Range: 0 mm–655 mm
o Value: 0.3
 Vibration Suppression Level
o Description: The larger this value, the stronger the suppression of the
material vibration during machining and the lower the follow sensitivity.
o Range: 0–5
o Value: 1
 Servo Compensation Parameter