WEIHONG Ncstudio V15 User Manual

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
53 / 116
 Nonmetal Calibration
o Description: Specifies the type of material to be calibrated.
o Range
 Yes: Non-metal materials, such as wood or glass.
 No: Metal materials.
o Value: No
 Touch Part Capacitance
o Description: Capacitance expressed in frequency unit when touching the
plates
o Range: 0-10,000,000 Hz
o Value: 0
 Calibration Length
o Description: During calibration, capacitance data within this length will be
recorded. This parameter can be lowered if the Z-axis travel range is short.
o Range: 5 mm–50 mm
o Value: 18
 Touch part speed
o Description: The speed of the part touching movement during calibration.
o Range: 0 mm/min–10000000 mm/min
o Value: 80
 Calibrating Speed
o Description: Indicates the calibration speed.
o Range: 0 mm/min–10000000 mm/min
o Value: 80
 Capacitance fluctuation detection
o Description: Calibration will be stopped if the capacitance fluctuation every 1
mm is less than this value.
o Range: -
o Value: 30
4.3.5 Speed Setting
Includes the following parameters:
 G00 Speed(Z)
o Description: The Z axis upward and downward dry movement speed. If this
value is large, the Calibration Length needs to be increased to allow
enough distance for axis deceleration to avoid collision with the material.
o Range: 0–axis maximum speed
o Value: 15000
 Follow Acceleration
o Description: The acceleration during following.
o Range: 1000 mm/s
2
–50000 mm/s
2
o Value: 12000
 Max Speed of Axis(Z)
o Description: The following speed and G00 speed cannot be larger than this
value.
o Range: 1mm/min–100000mm/min
o Value: 30000
 Max Motor Speed of Axis(Z)
o Description: Indicates the maximum speed of the Z-axis motor.
o Range: 1000 r/min–20000 r/min

WEIHONG Ncstudio V15 Specifications

General

Brand	WEIHONG
Model	Ncstudio V15
Category	Control Systems
Language	English