Specialized Concentrated Focused
System Page「23」
1. Back REF Point
2. Rect Machining
3. Select Line No
4. Machining Info
Operations
5. Park MCS Site
6. Select WCS
All Home
Z Home
X Home
Y Home
A Home
1. Params Setting
2. Load the Last
1. Park Mode
2. Park Site
7. Array Process
G54~G59 WCS
Fig. 3-7 Submenus under [Operations]
Press the Menu key ->3. Operations, and the press [OK] to enter its page, in which select the desired
menu item by the Up and Down key. Following is the [Operation] page.
2. Rect M achining
3. Select Line No
4. M achining Info
1. Back REF Point
Fig. 3-8 [Operations] page
Back REF Point
Return to the machine origin. For details, see chapter 4.6.
Rect Machining
The system offers rectangle milling wizard; after setting parameters successfully, press the Up and
Down keys to select [Load Now], and then press [OK] to load the machining file; and then you can
press to start machining.
You can also select 2. Load the Last, and then press [OK] to load the last rectangle milling and return to
the machining page, and then press to start machining.
Parameters X Init and Y Init decide the initial position of machining plane; Height and Width
decides the size of machining plane; two kinds of machining mode are available: Horiz. Mill (the feed
direction of tool is parallel to X axis) and Long. Mill (the feed direction of tool is parallel to Y axis);
EachDpth is the tool machining depth each time; generally, the value of EngrDpth (the total depth of
several millings) is set bigger than that of EachDpth; if the value of EachDpth is equal to or bigger
than that of EngrDpth, only one milling will finish the machining; NoseGap means the distance
between two adjacent lines, whose value should be set smaller than that of ToolDia to avoid missing
millings.
To Next Page
Loading...
