Specialized Concentrated Focused
System Page「27」
3.5.4. Parameter Upkeep (Parameter Maintenance)
Press the Menu key→ 6. Param Upkeep, and then press [OK] to enter the page, in which select a
submenu by pressing the Up and Down keys.
The submenus under this page are as shown in Fig. 3-15.
1 . B a c k u p P a ra m s
2 . R e s to r e B a c k u p
3 . F a c to r y P a ra m s
4 . E x p o r t P a ra m s
Param Upkeep
5 . Im p o rt P a r a m s
Fig. 3-15 Submenu list of parameter upkeep
Backup Parameter
Press [OK] to confirm backing up the parameters. No matter whether the parameter backup is
successful or failed, a prompt will be displayed.
Restore Backup
It is used to restore the backup parameters. If the parameters have not been backed up, Backup File
Not Found! will be displayed.
If the recovery is successful, a prompt of rebooting the system will be displayed, as shown in Fig. 3-16.
At this time, you can press [OK] to reboot the system directly, or [ECS] to return to the previous page.
Reboot
Immediately?
OK ESC
Fig. 3-16 Prompt dialog of system reboot
Factory Params
The action of ex-factory parameter recovery is to clear all the data and parameters interiorly set stored in
the system memory chip. It is necessary to perform this action when there are messy codes in the
interior file or after upgrade finishes.
Operate following the prompts displayed on the screen. After recovery is successful, a cue to reboot the
system will be displayed on the screen, as shown in Fig. 3-16. At this time, you can press [OK] to restart
the system, or [ESC] to back to the previous page.
The action of ex-
action is carried out accidentally and all the interior parameters are cleared, you can restore the backup
parameters by Restore Backup.
To Next Page
Loading...
