WEIHONG NK105 G2F - Page 38

Specialized Concentrated Focused
「26」System Page
For example: the modification method for the parameter REFP Speed is as follows.
Speed (mm/min)
X Axis:
1800.000
Y Axis:
1800.000
Z Axis: 1500.000
Fig. 3-12 Modification page of “REFP Speed”
Press Menu→ 5. Mfr Param→ 5. REF. PointSet→ 1. REFP Speed, and then press [OK] to enter the
page as shown in Fig. 4 3, and then press the Up and Down keys to select the axis speed parameter
to be modified. When the cursor is on an item, press [OK] and enter the new parameter value directly
and then press [OK] to save it.
CAUTION
If you switch to another parameter without saving the input value during parameter modification, this new value
will not be saved and the original value will be restored.
 Selection of Parameter Value
Select the parameter value by directly pressing the UP or Down key.
For example: the modification method for the parameter REFP Dir is as follows.
Hom ing Direction
X Axis:
Negative
Y Axis:
Positive
Z Axis: Positive
Fig. 3-13 Modification page of “REFP Dir”
Press Menu→ 5. Mfr Param→ 5. REF. PointSet→ 2. REFP Dir, and then press [OK] to enter the page
as shown in Fig. 3-13, and then press the Up and Down keys to select the axis direction parameter to
be modified. When the cursor is on an item, press the [OK] key to enter the interface as shown in Fig.
3-14, the arrow indicating the current parameter value. Press [Up] or [Down] key to select the desired
parameter value, and then press the [OK] key to confirm the modification.
Direction of X
· Positive
Negative
Fig. 3-14 Selection dialog