WEIHONG NK105 G2F - Default Chapter; Table of Contents

Specialized Concentrated Focused
「VI」Contents
Contents
1. Summarization ....................................................................................................... 1
1.1. Basic Configuration .......................................................................................................... 1
1.2. Introduction to Operation Panel ...................................................................................... 3
1.2.1. NK105G2 Operation Panel ..................................................................................................... 3
1.2.2. NK105G3 Operation Panel ..................................................................................................... 5
1.3. Introduction to NK105 Four Axes Control Box .............................................................. 8
1.3.1. Terminals on Control Box When General Software Is Installed .............................................. 9
1.3.2. Interfaces on Control Box ..................................................................................................... 12
1.4. Mechanical Dimension of Control Box and Handheld Box ........................................ 12
2. Principle of System Signal ................................................................................. 14
2.1. Binary Input Signal ......................................................................................................... 14
2.1.1. Binary Input ........................................................................................................................... 14
2.1.2. Binary Output ........................................................................................................................ 15
2.2. Open Collector Output Signal ........................................................................................ 16
2.3. Differential Output Signal ............................................................................................... 16
2.4. Analog Output Signal ..................................................................................................... 16
3. System Page ........................................................................................................ 17
3.1. Operation Mode and State .............................................................................................. 17
3.1.1. Operation Mode .................................................................................................................... 17
3.1.2. Operation State ..................................................................................................................... 17
3.2. Coordinate System ......................................................................................................... 18
3.2.1. Machine Coordinate System ................................................................................................. 19
3.2.2. Workpiece Coordinate System ............................................................................................. 19
3.3. Spindle State .................................................................................................................... 21
3.4. Manual Speed Type ......................................................................................................... 21
3.5. Menu Page ....................................................................................................................... 21