Specialized Concentrated Focused
「44」Machining Operations
machining file→ press to load the selected file.
Load an ENG File with Tool Selection Function
Find the desired ENG file following the steps above-mentioned to load an ordinary file, and then press
[OK] to select the ENG file to be machined, and then press to automatically enter the tool
selection page as shown in Fig. 4-17.
Number of tools: 2
Cutter 1: [Flat Bottom ]JD-6.00
Tool No.: 0
Fig. 4-17 Tool selection page
Number of tools: the number of tools in this ENG file
Tool No.: current tool No., selected by pressing the Up and Down keys
Cutter: selected by pressing the Up and Down keys, displaying tool sequence number and name
After parameters are set, press [OK] to load the file; after loading, the system will return to the machining
page automatically.
4.9.3. Set Workpiece Origin
Workpiece origin is the zero of X, Y, and Z/A in the machining file. Before machining, you must set
workpiece origin to determine its actual position.
Manually move the X and Y axes to the desired origin position, and then press for XY clearing,
i.e.to confirm the position of XY workpiece origin.
For Z/A workpiece origin, there are two ways to set it:
Method one is the same as that to set XY workpiece origin. Manually move the Z/A axis to the
desired origin position. And then press + for Z/A clearing, i.e. to confirm the position
of Z/A workpiece origin.
To Next Page
Loading...
