Specialized Concentrated Focused
「42」Machining Operations
4.8.2. Parameter Setting of Manual Machining
Basic parameters of manual machining include: rapid jog speed (i.e. High shown in the machining
page), jog speed (i.e. Slow shown in the machining page), XY step, Z step and A step.
Table 10 Parameters for manual machining
Two types of speed under manual
machining, deciding the axis motion speed
during manual machining.
0.06~Max. speed of machine tool
The motion distance of the corresponding
axis each time an axis direction key of
X/Y/Z/A is pressed.
The max. speed of a machine tool is related with the setting of pulse equivalent. For the concrete
expression, see Chapter 4.3.
Jog speed (Slow) and rapid jog speed (High) are switched by pressing
.
The concept of stepping (also called gridding in some other systems) is introduced for the accuracy
of machining and debugging. When the system is in the stepping mode, step is the motion distance
of the corresponding axis each time an axis direction key of X/Y/Z/A is pressed.
Under the main page, press the [OK] key to enter the parameter setting page of manual machining, as
shown in Fig. 4-13.
M Spd
StepXY
StepZ
File <FLOW ER.G>
3000/ 1500
10.000
1.000
1500
Fig. 4-13 Manual parameter setting page
Press Up or Down to select the desired parameter, and then press [OK] for confirmation after
modification. Note that modification should be within the parameter range.
Current file name is displayed at the bottom of the LCD. Press Up or Down to move the cursor to the
file name, and then press [OK] to enter the file list of C disk, as shown in Fig. 4-14. You can only load
these files, unable to delete or copy them under this page.
FLOW ER.G
Testing.dxf
Tool.nc
C：
[OK] Load
Fig. 4-14 File list page
If there is no file in the C disk, the prompt File Not Found, Show USB File? will be displayed; press [OK]
To Next Page
Loading...
