WEIHONG NK105 G2F - 5.3. Adjustment during Automatic Machining

Specialized Concentrated Focused
「50」Machining Operation of NK105G3F
Where:
Press
-
or
-
.
-
to increase or decrease the feedrate override.
5.3.2. Spindle Speed Adjustment
Spindle speed are adjusted by pressing combination key +
-
or +
-
.
-
, and
divided into 11 gears from 0.5s to 1.5s with speed increasing sequentially.
5.3.3. Machining Pause and Jiggle
Refer to chapter 4.10.3 for details.
Where:
Press + to enter the jiggle page.
5.3.4. Soft/Hard Limit Handling
Refer to chapter 4.10.5 and chapter 4.10.6 for details.
5.3.5. E-stop Handling
When E-stop occurs, the system will stop machining, and give an alarm as shown in Fig. 5-2, the ALM
indicator on the panel ON. Before executing any other operations, remove this alarm by turning the
E-stop button clockwise.
After E-stop alarm is removed, home all the axes, and then press + to execute breakpoint
resume, i.e. to resume machining from the stop position when E-stop occurs.
1X 15.617 Estp
1Y 551.107 SOff
1Z 9.900 Slow
Jog
ESTOP2
Fig. 5-2 E-stop alarm
CAUTION
In E-stop state, all the other keys are invalid except the “Menu” key. You can press the “Menu” key to enter the
menu page and make desired changes.