WEIHONG NK105 G2F - Page 68

Specialized Concentrated Focused
「56」References
 Parameters Related with Tool Change
Parameter
Meaning
Setting range
ATC Capacity
Capacity of tool magazine
1~20
Current ToolNo.
Tool No. currently used
1~Value of ATC Capacity
Tool Offset
Modification to the tool offset along each axis
X/Y/Z: -10000~10000 mm
ToolChangeTip
Whether to send prompt when there is tool change
command in the file
Yes: Valid; No: Invalid
X/Y/Z Cali Coor
The machine coordinate (X/Y/Z) of tool presetter in
fixed tool measurement
/
CaliToolHeigh
The required tool lifting height after the end of tool
measurement
0.001~9999 mm
 Ignore Command
Parameter
Meaning
Setting range
Ignore F Code
Whether to enable the feedrate
command in the machining file
Yes: Enable the feed rate in the system
No: Enable the feed rate in the
machining file
Ignore S Code
Whether to enable the spindle
command in the machining file
Yes: Enable the spindle command in
the system
No: Enable the spindle command in the
machining file
7.1.2. Parameters of Manufacturer’s Access
 Parameters Related with Velocity
Parameter
Meaning
Setting range
Decel. Dist.
To protect tools, the machine tool will decelerate (at
[Approach Speed]) when approaching the target
position during positioning. This parameter is used
to specify the distance from the decelerating
position to the target position.
0~999mm
Approach
Speed
It is the feed speed of the tool when approaching
workpiece during positioning (the distance between
the tool and workpiece is smaller than deceleration
distance).
Jump speed ~ Machining
speed
Sgl Axis Acc.
Description of the acceleration/ deceleration
capability of each feed axis, in 
2

0.001~100000.0mm/s
2
Max. Turn Acc.
The max. acceleration of feed motion on adjacent
axes
0.001~100000.0 mm/s
2
Jerk
The change rate of acceleration of single axis

0.001~100000.0 mm/s
3
Max. Speed
It specifies the max. speed of X, Y, Z and A axes.
0.06~100000.0 mm/min