上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
- 8 - Specialized, Concentrated, Focused
User interface: interactive, simple and user-friendly design, featuring convenient operation.
Operation buttons: including ―State‖, “Advanced‖, ―Program‖, ―Parameters‖, and ―System‖.
Keyboard: each letter key contains one bigger letter and smaller letter, the smaller locating at the
top left while bigger one, which supports capital entering only, at the lower right. If you want to enter
the bigger letter, just press the corresponding letter key; for the smaller one, pressing the shift key
and the letter key simultaneously is required.
The Num keys can also work as axis feeding buttons, as follows:
X1
7
Z+
X1
8
Y+
X1
9
IV+
X1
4
X-
X1
5
X1
6
X+
X1
1
Z-
X1
2
Y-
X1
3
IV-
X1
*
V+
X1
＇０
X1
& 。
V-
In auto and home mode, the Num buttons are
used to enter number.
In manual, jog and stepping mode, the Num
keys are used to manipulate the movement of
corresponding axes. Among them, the num key
―5‖ is used to switch between the manual high
speed and manual low speed.
System operation buttons: including insert, back space, delete and so on.
Mode selection buttons: shown as below:
Auto
JOG Handle REF. Point
The operation mode can be divided into 4
types: auto mode, manu mode and REF. point
mode. The manu mode can be further divided
into jog mode, stepping mode and handwheel
mode.
Stepping mode buttons
XUD：custom step length.
X1：step length of 0.001 mm or inch。
X10：step length 0.01 mm or inch。
X100：step length of 0.1 mm or inch。
Auxiliary buttons: mainly including:
Simulate
SIM
Single Block HW Guide
Used for simulation, single block and
handwheel guide respectively.
Simulate
SIM
Single Block HW Guide
Controlling workpiece cooling, air and
lubrication switch respectively.
To Next Page
Loading...
