WEISS TR0750A - User Manual

Questions and Answers

J
Jeffrey AllenJul 25, 2025
Why is the output flange/rotary ring on my WEISS Industrial Equipment not rotating?
- C
  Cassandra WilkersonJul 25, 2025
  If the output flange or rotary ring of your WEISS Industrial Equipment isn't rotating, several issues could be the cause. First, the toothed belt between the motor and gear may be torn and needs replacement. Second, there might be no motor supply voltage, so measure the voltage, check all fuses, and inspect the motor protection switch. Finally, the motor itself could be inoperable and need to be replaced.
G
glenncontrerasJul 30, 2025
What to do if the output flange overtravels a position on WEISS TR0750A?
- T
  Todd RosalesJul 31, 2025
  If the output flange of your WEISS Industrial Equipment overtravels a position, it could be due to several reasons. The rotary switch on the controller board may be set to an excessively high stop delay time, so set a correct stop delay time with the rotary switch. Also, the holding brake might be worn and needs replacement. Finally, contact erosion at the motor contactor could be the reason, so replace the motor contactor, using a semiconductor relay if required.
C
christopherbenderAug 6, 2025
How to fix a mechanically blocked output flange/rotary ring on WEISS TR0750A Industrial Equipment?
- M
  mitchellgabrielleAug 6, 2025
  If the output flange or rotary ring of your WEISS Industrial Equipment is mechanically blocked, verify that it is not blocked at the top or underside and remove the cause of the block. Also, check the gap between the rotary ring and stationary plate for any extraneous objects and remove them.
Q
qsmithAug 12, 2025
What to do if the output flange/rotary ring of WEISS TR0750A Industrial Equipment is subject to mechanical tension?
- S
  sbeckAug 12, 2025
  If the output flange or rotary ring of your WEISS Industrial Equipment is subject to mechanical tension, verify that the mounting site is level and the mounting is correct. Also, verify the installation.
Q
qhaleAug 18, 2025
How to clean pollution between rotary ring and stationary plate on WEISS Industrial Equipment?
- S
  sfrancisAug 18, 2025
  To address pollution between the rotary ring and stationary plate on your WEISS Industrial Equipment, dismount the stationary plate and the rotary ring and clean both. Then, perform a test run without the rotary ring and stationary plate.