WEISS TR0750A - Passage of Media

79 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Rotary indexing ring TR

Product description

3.7 Passage of media

The inner opening [1] can be used for the pas-

sage of media.

16 / 79

Mounting instructions_062019_4.0_en

Table of Contents

Default Chapter2
- Table of Contents2
1 Introduction5
- About These Mounting Instructions5
- Intended Use5
- Predictable Incorrect Application5
- Applicable Documents6
- Warranty7
2 Safety8
- Safety Messages and Hazard Categories8
- Hazard Symbols8
- Responsibilities of the System Integrator And/Or Operator9
- Qualification of Personnel9
3 Product Description10
- Overview10
- Function Description12
- Nameplate13
- Type Code13
- Mounting Positions14
- Drive Positions15
- Passage of Media16
4 Technical Data17
- General17
- Motor17
- Holding Brake20
- Inductive Sensor20
- DRIVE-Cliq Encoder (Optional)20
- Climatic Environmental Conditions "Operation21
- Climatic Environmental Conditions "Transportation and Storage21
- Dimensions22
- Load Data26
5 Packaging27
- Types of Packaging27
- Unpacking the Product27
- Verification of the Delivery27
6 Transportation28
- Transporting the Product28
- Load Lifting and Handling Equipment29
- Fastening the Load Lifting and Handling Equipment29
7 Storage31
- Storing the Product31
8 Mounting32
- Prerequisites for Mounting32
- Equipment and Tools32
- Tightening Torques and Property Classes33
- Bolting down the Product33
- Displacing the Drive Housing34
- Mounting Additional Components36
- Mounting Safety Equipment39
9 Electrical Connection40
- Connection Diagram Supply Voltage40
10 Controller42
- Basic Information on Control42
- External Controller (PLC)43
11 Commissioning45
- Prerequisites for Commissioning45
- Performing Commissioning45
12 Operation47
- Basic Information on Operation47
13 Troubleshooting48
- Issue, Cause and Remedy48
14 Cleaning50
- Performing Cleaning50
15 Maintenance52
- Maintenance Plan52
- Lubricant52
- Replacing the Motor52
- Inspecting the Toothed Belt57
- Replacing the Toothed Belt59
- Inspecting the Holding Brake62
- Readjusting the Air Gap of the Holding Brake64
- Replacing the Holding Brake67
- Replacing the Inductive Sensor72
16 Decommissioning76
- Decommissioning the Product76
17 Dismounting76
- Dismounting the Product76
18 Disposal76
- Disposing of the Product76
19 Service and Spare Parts77
- Worldwide Service77
- Ordering Spare Parts78

Related product manuals

Preview: WEISS TC Series

WEISS TC Series

Preview: WEISS ST Series

WEISS ST Series

Preview: WEISS NR Series

WEISS NR Series